Balancing Board for 1-4 Cells LFP (1.2 AMP)

Battery balancer (equalizer) for 1 to 4 LFP (LiFePO4) cells with balancing current up to 1.2 A.

Simple balancing board for 1S to 4S LFP cells. Connection by means of wires. Indication of the balancing by LED diodes. This balancing board can be used to balance LFP cells during the final part of the charging process.

The battery balancer balances the voltage between the batteries - it balances to the maximum voltage difference between the batteries. This improves the performance and life of the batteries connected in the battery pack.

• An easy connection to LFP cells by a JST XH 2.50 5pin connector (socket).


• The board works with 1S up to 4S cells.


• Increased balancing possible by multiple parallel connections.


• You can disconnect the board from the pack when balance is not in use.

Information:

For transport, there is a plastic holder below the resistors. Remove the plastic holder after installation and before the operation of the board.

After removing the plastic holder, the resistors are above the board to release the head into the surrounding area. Protect the resistors against mechanical damage.

Note:

During the operation the resistors are very hot. Be careful about and avoid touching the resistors.

Warning:

Avoid any contact of human skin or other easily melting materials when the resistors are heated.

If you do not plan to balance your pack, disconnect the 4S balancer from the cables permanently. We recommend complete disconnection of any components when you stop using your pack.

SPECIFICATIONS

Support for LiFePO4: 1S to 4S cells

Balancing voltage: 3,60 V (+/- 25 mV)

Balancing resistor: 3,0 Ω

Balancing current: 1,0 to 1,2 A

Self-consumption: < 0,05 mA

Connector: JST XH 2.50 5pin (socket)